Standard 22 Moderator 1/2 UNF x 20

[Back_Roads]

 I'm starting to think I over think this 3D stuff

[bduares]

My nerdy lithophane experiment:

Are you printing that with an FDM or Resin printer?

[OldCrow]

NOTE;  I'll be updating the moderator designs on thingiverse to support the following thread patterns.
1/2x20, 1/2x28, M10x1. M14x1, M14x1.25, M16x1, M18x1, M19x1.5 and M20x1

These are all printed threads. 

Done

[Robert 5mm]

NOTE;  I'll be updating the moderator designs on thingiverse to support the following thread patterns.
1/2x20, 1/2x28, M10x1. M14x1, M14x1.25, M16x1, M18x1, M19x1.5 and M20x1

These are all printed threads. 

Done

One more thread if you could please - M20x2 for the Standard and Wraith.

Thanks for all your work

[OldCrow]

NOTE;  I'll be updating the moderator designs on thingiverse to support the following thread patterns.
1/2x20, 1/2x28, M10x1. M14x1, M14x1.25, M16x1, M18x1, M19x1.5 and M20x1

These are all printed threads. 

Done

One more thread if you could please - M20x2 for the Standard and Wraith.

Thanks for all your work

What guns use that?

[Robert 5mm]

Buck Rail adapters use M20x2 for different manufacturers - Beeman, Crosman, Benjamin

[OldCrow]

Buck Rail adapters use M20x2 for different manufacturers - Beeman, Crosman, Benjamin

Ok, I'll try to get it up to Thingiverse this week.  I'm running some pretty big OpenScad scripts right now and they're going to take 24 hours or so to finish.  When they are done I'll get that done.

[TorqueMaster]

My nerdy lithophane experiment:

Are you printing that with an FDM or Resin printer?

That was FDM, Ender 3, white PLA.  It prints standing on edge, roughly 3.5mm thick for the darkest parts, and probably 0.4 or 0.5mm for the lightest areas.    The source image file was only 600 x 330 -- it might look less edgy with a higher res image.

[bduares]

Oh, ok. Might give that a try then. I never did a litho because I thought they were for resin printers

[OldCrow]

NOTE;  I'll be updating the moderator designs on thingiverse to support the following thread patterns.
1/2x20, 1/2x28, M10x1. M14x1, M14x1.25, M16x1, M18x1, M19x1.5 and M20x1

These are all printed threads. 

Done

One more thread if you could please - M20x2 for the Standard and Wraith.

Thanks for all your work

You are very welcome, sir.  This task has been completed for all the moderator designs which are large enough in diameter to support an 20mm thread.  Your M20x2s are up there.  Resolution of those stls is about double that of the ones already on the site.  That makes the file size larger.

[Robert 5mm]

OK thanks again, I will be going to Thing next