The engineer said the barrel is 22" long. Is that 19" going to be long enough to reach the barrel band?
Yeah I saw that, and he stepped in and said it was 22". It's in one of these threads.
The engineer said the barrel is 22" long. Is that 19" going to be long enough to reach the barrel band?[/quotQuote from: avator on January 10, 2022, 08:49:32 PMThe engineer said the barrel is 22" long. Is that 19" going to be long enough to reach the barrel band? There is 3 1/2 or so of barrel past the band so 19 would be about minium to go.
question about the barrel band...is the barrel friction fit or is there a set screw? I like how Crosman used a through bolt and recessed nut to hold it together rather than a spring pin but curious if also compresses the barrel band around the barrel preventing barrel movement?
question about the barrel band...is the barrel friction fit or is there a set screw? I like how Crosman used a through bolt and recessed nut to hold it together rather than a spring pin but curious if also compresses the barrel band around the barrel preventing barrel movement?[/quoteQuote from: Spooner on January 10, 2022, 09:13:27 PMquestion about the barrel band...is the barrel friction fit or is there a set screw? I like how Crosman used a through bolt and recessed nut to hold it together rather than a spring pin but curious if also compresses the barrel band around the barrel preventing barrel movement? There is a tiny set screw on top, the .05 mm same as breach screw, I already replaced my plastic breach's screw with the fancy aftermarket one. I feel better with it in there .
Ordered mine this morning, and it looks like they didn't charge sales tax. I'm not in a rush either. I might have a chance to play with it by the end of next week.
The .25 barrel I'm planning to use is around 19 inches. I need to pull it back out of the breech for a good measurement.
Found my scope mounts, 10m 5 shot groups, 7 pumps, Air Arms 16 gr. Pellet in the hole is .30 cal. Bad scattered target to the right is from my home cast wad cutters @ 7 pumps, but they settled in with 4 pumps. Next up is see how Poly-Mags fly. BTW the scope is a UTG 4-16 x 40, about a 14 oz. scope, seems to be holding true with the Buck Rail 3D Printed Mounts, I did go and snug them up after about 30 shots and they were still good, but figured an extra re torque would not be a bad idea.
Quote from: EdinGa on January 10, 2022, 08:41:27 PMThe .25 barrel I'm planning to use is around 19 inches. I need to pull it back out of the breech for a good measurement.Where did you source the barrel? Is it one of those Baker Airguns barrels that are no longer available?
Advertise Here
Share This!