What airgun related did you do today?

[Ronfiveo]

I have been slightly shooting FrankenDaisy just holding my breath that every time I cock it
it does ok.

I'm kinda just waiting for the third shoe to drop.
So far so good and its shooting single smooth hole groups at  10m.

Ron

[sekiar]

Ended up mounting my new pistol scope on my new Diana pistol with the rifle barrel for a long range pistol shooter, now to just get it sighted in and I'll be ready to test out at + 20 yards or so.  Charles

[2A Georgia]

Gunsmithing and porting the .303 Challenger.  Posted here
https://www.gatewaytoairguns.org/GTA/index.php?topic=205615.new#new

[Ronno6]

I resealed a V.1.5 Crosman 766, a Daisy 856 and Model 90.

[Matchstickshooter]

 Working on removing a bent piston lever and replacing it with new, on a Crosman Stealth springer.

[Matchstickshooter]

And the Crosman Stealth is back up and working fine.

 Last owner bent the piston lever, badly (including putting a crack in the edge of the forearm where the lever hit).
In the middle of the lever is a little post with a roll on it that rides up and down a (greased) channel inside the stock.
That fell out when I took the gun apart. The hole it left is where the stock bent.

Had to "manufacture" another rivet.
 





 Wearing a Winchester scope

[Back_Roads]

 Mowed the range, now it's naptime

[2A Georgia]

PCed half a tin of 19.4 NOE to see if I can get a group as tight as the Apollo 18s from the ported and plenumed Notos....I guess I'm going to have to hand pump tomorrow...

[Matchstickshooter]

 Crosman Stealth...meant to say "the hole is where the lever bent"     Senior moment.

[Whirligig]

I have been slightly shooting FrankenDaisy just holding my breath that every time I cock it
it does ok.

I'm kinda just waiting for the third shoe to drop.
So far so good and its shooting single smooth hole groups at  10m.

Ron

It sounds like you have mastered shooting that air gun.

-W

[Ronfiveo]

I have been slightly shooting FrankenDaisy just holding my breath that every time I cock it
it does ok.

I'm kinda just waiting for the third shoe to drop.
So far so good and its shooting single smooth hole groups at  10m.

Ron

It sounds like you have mastered shooting that air gun.

-W

Probably not mastered, but getting the hang of it better.
I know that when I do have bad days it's not the rifle.
It gives me hope knowing that it can be done.

Ron

[Jshooter71]

Daydreaming about shooting for a minute while cooling off… back to work now. 🤪

[maraudinglizard]

Worked on the Factor's single shot tray, the bolt would not go through it at all. Took a wooden dowel and sand paper to ream it out. Still a tad hair tight but the bolt does close now. Check the magazines for fitment as well. Scope went on with no problems. Just waiting for the weather to clear up some to shoot it.

[Blowpipe Sam]

I added a third grub screw to the TKO suppressor I modified to fit a Crosman 1400. If this works I’ll post pictures of the results.

[Matchstickshooter]

 RC bearing mod to the Crosman Stealth. MUCH BETTER!

[bear air]

I haven't done much lately with the heat and tight finances. I was able to get a 500 count of 156 gr .357 slugs from Pro slugs this last week. I counted them out today putting together 50 count containers.

[airgunaut]

Heat, monsoony storms, and intense sunlight have cut down on my shooting. Counting out pellets is a good use of airgun time, for those who mete out portions (I do, too). It’s about time for me to inspect and count another tin or two anyway, one for the P3 and one for the 880.

Cutting cardboard into the right size for targets is another dull but helpful airgun-related task.

[bear air]

I also installed a sling onto my m25. And started contemplating swapping some cases around between rifles.

[sekiar]

Adjust several  CO2 Diana triggers today and what a super great trigger these are.  I have a fair number of HW rifles and these Diana are just as good!  Just my opinion.  Love both!  Charles

[Back_Roads]

 I discovered why I put tactical lights on some of my airguns, I was shooting this afternoon in the basement range when the lights flickered, then went dead. After a few shots in the dark, I just awoke from a power nap , I remembered the Notos has an Olight mounted to it and I just had to push a button and continue plinking. 
 super time was getting close, and power was a good hour or so to being restored, so Sue and I took a ride down to the fire dept. picnic and they had power and gas grills and deep fryers going. We had a couple cheese burgers fries and deep fried cheese curds, washed down with a couple Carbless brand  adult beverages " not bad for a fizzy fruit beverage", while jamming to a classic rock cover band, before heading home to a message on the answering machine from the power co, stating we now have power back