Do some new 392 parts fit older 392s?

[floydlong]

I have a 392PA that Crosman calls a Phase 1. I need a bolt, breech seal, bolt spring and screw, front end cap, and a side plate cover that covers where you take the bolt screw out for removal. Wondering if the newer parts would fit. It looks like the front end cap will as it's the same part number throughout, however, wondering if any one knew about the bolt, etc. ??
Thanks

[bbv13]

I have a 392PA that Crosman calls a Phase 1. I need a bolt, breech seal, bolt spring and screw, front end cap, and a side plate cover that covers where you take the bolt screw out for removal. Wondering if the newer parts would fit. It looks like the front end cap will as it's the same part number throughout, however, wondering if any one knew about the bolt, etc. ??
Thanks

I have a Racine Benjamin 397 and a Phase 2 392. There may be a few parts that interchangeable but I think it would be easier to put together a parts list and contact Mac1 and Baker Airguns to see if you can just buy the parts you need.

Bryan

[longhunter]

what he said^^. plus, the quality of the new parts may, or may not be up to snuff. I'd only order new parts for an old gun as a last resort.

[DD789]

Mac1      http://www.mac1airgunshop.com/sheridan-rocker-bolt-lug-p/m1bilevki.htm
                 http://www.mac1airgunshop.com/steroid-front-plug-p/m1stfplug.htm

[floydlong]

I found all my parts at Crosman except the bolt assembly and Baker had that. Good to go. Thanks for your replies.