Author Topic: Alternative to boring out the receiver to accept a sleeved barrel (Read 1873 times))

Tomg · « **on:** February 20, 2015, 01:16:11 PM »

This is what I have done, using my BNM breech.

It's very stiff now.

And it shoots nice now, 6 shots a 37yds.

rsterne · « **Reply #1 on:** February 20, 2015, 01:31:05 PM »

Is the breech collar pressed onto the breech?.... Looks like a good design....

Bob

Rdsail · « **Reply #2 on:** February 20, 2015, 01:39:20 PM »

Nicely done!

Tomg · « **Reply #3 on:** February 20, 2015, 02:59:33 PM »

Thanks!

Bob, yes it's a tight fit, with two threaded 10-32 into the receiver to hold it in place.
I was toying with the idea of threading the whole thing so I could screw it onto the BNM. Maybe when I get good at the lathe thing:-)

azoutdoorsman · « **Reply #4 on:** February 20, 2015, 10:44:19 PM »

Nice job, as usual!

rsterne · « **Reply #5 on:** February 20, 2015, 10:51:02 PM »

A tight fit, the shoulder it sits against, and the 2 screws, should do the trick....

Bob

Tomg · « **Reply #6 on:** February 22, 2015, 01:37:36 PM »

Took another picture of the inner collar, that sits tight around the cf portion of the sleeved barrel. The outer cf is the shroud, if it wasn't obvious:-)

Thank you to our advertisers!

Alternative to boring out the receiver to accept a sleeved barrel

Author Topic: Alternative to boring out the receiver to accept a sleeved barrel (Read 1873 times))

Tomg

Alternative to boring out the receiver to accept a sleeved barrel

rsterne

Re: Alternative to boring out the receiver to accept a sleeved barrel

Rdsail

Re: Alternative to boring out the receiver to accept a sleeved barrel

Tomg

Re: Alternative to boring out the receiver to accept a sleeved barrel

azoutdoorsman

Re: Alternative to boring out the receiver to accept a sleeved barrel

rsterne

Re: Alternative to boring out the receiver to accept a sleeved barrel

Tomg

Re: Alternative to boring out the receiver to accept a sleeved barrel