what do you guys think of the tunning kit for hatsan 125 that wolf airgun sells

[mad187]

have the old type hatsan whit thumb hole stock and thinking of buying the spring tune kit from wolf airguns for it .does anybody here know if it is any good?

http://www.wolfairguns.com/product_info.php?cPath=27&products_id=34

[Hobbyman2007]

I would sooner buy for ARH . Not sure about putting another spring in a riffle that's already a bear to cock . I would imagine the shot cycle would be pretty harsh ,not to mention putting oil on the piston? Sounds kind of gimmicky.

[mad187]

okey .good thing i ask first havent seen  any tuning springs for hatsan on ARH site .do you have link ?

[Hobbyman2007]

I'd call and ask. I don't have the spring specs for the 125. It should be the same spring as the walther falcon hunter or webley patriot.

[Hobbyman2007]

I think this is the spring you want. http://www.airrifleheadquarters.com/catalog/item/251488/8827943.htm
Again I'd call first.

[Paul68]

The .148 wire diam spring will likely require the inner diam of the piston to be enlarged. In other words, probably wont be a direct fit and you'd have to bore out the piston.

The OEM specs for the 125 spring is .142 wire diam, 47 coils.

Vortek makes a 125 replacement spring with higher pitch rate and fewer coils. I have yet to try one or see it tried.

http://vortekproducts.com/ourstore/airgun%20Springs/OEM%20Springs?product_id=185

[ancient1one]

I do not know about tuning spring rifles but have read about Wolf in Poland. They do not stand behind what they sell. If you have a problem it is hard to get a refund from Wolf. . Wolf sold faulty lcd's this spring/summer and most guys had trouble getting a refund. 

I will look for the thread.

[ancient1one]

Link: http://www.gatewaytoairguns.org/GTA/index.php?topic=75943.10;wap2

Their are more on GTA if you search.

[mad187]

vortekproducts.com does not seem to shipp to norway 

[ancient1one]

vortekproducts.com does not seem to shipp to norway 

Have you contacted Vortek? Call or send them an email.

[mad187]

yes did email them .havent answer yet .but did not find norway in the list of countrys.wud like to order that DIANA48/460/56 PG2  tuinng kit for my bam b21 177 also

[ancient1one]

Vortek sells and ships all over the world. If they do not reply to your email in a couple of days I would send another.

If you speak english and have access to an international phone line give them a call. I am sure they will sell and ship Vortek kits for your rifles.

[mad187]

it looks like this orginal spring has been cut down.there where no pressure when i took out the locking pin so i had to cock the barrel a little to get out the spring and the rear cap.the spring was 30cm,shall they not be longer?

[Paul68]

That spring looks like it was broken and the previous owner just smoothed the broken end and put it back in. If there was no preload, I'd pretty much guarantee it. Don't worry about length. Count the number of coils. There should be 47 coils on a factory 125 spring. Below is what the ends of your spring should look like.

[mad187]

i got one orginal patriot spring and one tuning spring for patriot they both have 40 coils .does any one know if i can use them?

[mad187]

the patriot spring did not fit in the hatsan piston.but i did buy the spring tuning kit from wolf airguns and i did not use the inner spring just the normal spring and orginal spring guide.but it is impossible to cock the airgun whit that spring think i need to cut of some coils

[PIPERMAN]

have the old type hatsan whit thumb hole stock and thinking of buying the spring tune kit from wolf airguns for it .does anybody here know if it is any good?

http://www.wolfairguns.com/product_info.php?cPath=27&products_id=34

Better forget it.
You can buy the original spring here,it's very cheap

http://www.air-rifles.eu/product/Spare-parts-air-rifles_Mainspring-air-rifle-Hatsan-125

[mad187]

they do not shipp to norway