Hatsan 95 Quattro triger tear down....HELP!

[JOSEPH7217]

tore down trigger things going good. had hard time putting back together ,particularly the large sear getting pin back in. well now that i have it back together the piston wont engage/latch onto large sear and latch. appreciate any help or advice getting my trigger back together  and on track. thanks j

[Airgun.Sniper]

Do you happen to have any pictures? If I can find some of mine i maybe be able to help

[SpiralGroove]

Hey Joseph7217,
Send me a PM (personal message) and I should be able to help
Kirk

[D14Jeff]

sounds like it's adjusted too soft or reassembled incorrectly . these links may help .

http://www.network54.com/Forum/79537/thread/1301669829/Hatsan+Quattro+trigger+

http://www.airgundepot.com/understanding-the-quattro-trigger-adjustments-article.html

[mafatone]

Here is the ultimate understanding, tuning, repair, disassembly and assembly made for your 95.   



Link removed. Unsafe practices by a member that was banned from GTA.
Dave

[Badgerfan]

Thanks for posting those links - they may come in handy for me someday.

[topwaterjim]

x2 on the link Dennis posted. Very thorough

[Paul68]

Very common issue when reassembling the Quatro. The part that gets you is the way the lower sear drops after you put the pin back in. Most folks like to lift the sear back up, which doesn't work and ends up causing the gun to not want to cock. Let the sear drop loose after you get the pin back in.

If you still have trouble, remove the spring, put the trigger assembly back in, then cock the rifle while it is out of the stock and watch how the trigger behaves. That should show you what happens and what to do.

[Paul68]

Took a moment to check out the links. At the moment I wont remove them because this is not my gate to moderate. I will however warn against following the advice and examples shown in those links. The author is banned from GTA, and just watching his videos reminded me why. Replacing a trigger sear pin with a smaller one that introduces slop into the sear operation is one good example. It does not matter if replacing it makes it easier to put the assembly back together, and that is a poor reason to make such a change, and it degrades the operation of the sear. Put it together properly, or leave it alone. Another is advising to polish entire sear surfaces, including critical friction points. Another is advising to load a trigger assembly with grease. Please, DO NOT take what is there as sound advice. Quatro triggers can easily produce dangerous misfire conditions if not properly serviced and assembled.

[eeler1]

Oops, wrong place, ignore please

[JOSEPH7217]

thanks one and all for your help. found a link for tunning 95 trigger on the yellow last night and in the nick of time. mike did a awesome job and was very helpful with advice ,i am very thankful. now 95 is shooting awesome...happy new year j 

[mafatone]

But nobody said he wanted to replace the pin. He wanted to know how to put his back together. Oh well, I tried. Didn't know the guy was banned.