Author Topic: Hello All (Read 1312 times))

shooter1020 · « **on:** October 22, 2013, 04:34:35 PM »

Just purchased my first PCP air rifle from PA an MROD 25 cal. Still anxiously awaiting arrival of same. Can't wait to get shooting.

Chris

Geoff · « **Reply #1 on:** October 22, 2013, 05:01:41 PM »

Greetings and well met. Welcome to GTA.. plenty of people here to offer advice if you have questions inre the 25 call mrod, or any other rifle

Roadworthy · « **Reply #2 on:** October 22, 2013, 05:38:49 PM »

Hi, and welcome to the GTA!! Check out the darksiders area, other than that Geoffrey covered it pretty well.

maripaul · « **Reply #3 on:** October 22, 2013, 05:54:26 PM »

Welcome from another newbie. Great choice of gun. Hope to be able to upgrade to one in the next year. Like so many folks on this great web site have said. Shoot - shoot - shoot. You have a great family of experts on just about any topic or question.

I just figured out how to use images - so below is a few images of my set up for pellet and weapons testing:

This is just an introduction to my semi-indoor pellet testing range setup. The pellet trap was built by a carpenter friend out of 3/4" plywood. Behind the black plastic foam material are layers of old carpet, 3/4" plywood at a 45 degree angle as well as heavy canvas and recently some duct seal. Most of the pellets fall to the bottom of the unit. Over time faster pellets from the Gamos punched through the back wall of the system. That resulted in adding additional 3/4" plywood sections to the back side twice! A close look will reveal the Harbor Freight moving dollies on the bottom. I am able to move this assembly as needed on these dollies.

I use 2 100 watt bulbs in the reflectors that point straight down on the chronometer in order to get a consistent amount of light for the sensors on the chrono to work reliably. There is also a photo of the remote chrono display for these aging eyes.

My semi-indoor test range

Close up of the pellet trap and targets used

Front view of trap

Rear view of trap

Close up of chrono display, printer, light switch, clock, and etc.

Airgun.Sniper · « **Reply #4 on:** October 22, 2013, 06:29:30 PM »

Welcome to GTA

dk1677 · « **Reply #5 on:** October 22, 2013, 07:38:34 PM »

Welcome to the GTA Chris!

shooter1020 · « **Reply #6 on:** October 22, 2013, 07:54:02 PM »

Thanks to all for the warm welcome, much appreciated.

Chris

amb5500c · « **Reply #7 on:** October 22, 2013, 08:09:54 PM »

Welcome to the GTA.
Richard

OleTomCat · « **Reply #8 on:** October 23, 2013, 01:49:03 AM »

Chris,

Welcome to our Addiction..........

Thank you to our advertisers!

Hello All

Author Topic: Hello All (Read 1312 times))

shooter1020

Hello All

Geoff

Re: Hello All

Roadworthy

Re: Hello All

maripaul

Re: Hello All

Airgun.Sniper

Re: Hello All

dk1677

Re: Hello All

shooter1020

Re: Hello All

amb5500c

Re: Hello All

OleTomCat

Re: Hello All