Introduction

[JoseMurra]

Hi,

My name is Jose, I am an avid airgunner I found this forum to find and post information about new aiguns.

[Roadworthy]

Welcome to The GTA, Jose!!  That is certainly what this forum is for.

[maripaul]

Welcome to a great web site Jose. The people here are great and willing to share the vast amount of information they have. Just ask!

Shoot, shoot, and keep shooting.

Again, welcome from another newbie.

[dk1677]

Welcome to the GTA Jose!

[maripaul]

This is just an introduction to my semi-indoor pellet testing range setup. The pellet trap was built by a carpenter friend out of 3/4" plywood. Behind the black plastic foam material are layers of old carpet, 3/4" plywood at a 45 degree angle as well as heavy canvas and recently some duct seal. Most of the pellets fall to the bottom of the unit. Over time faster pellets from the Gamos punched through the back wall of the system. That resulted in adding additional 3/4" plywood sections to the back side twice! A close look will reveal the Harbor Freight moving dollies on the bottom. I am able to move this assembly as needed on these dollies.

I use 2 100 watt bulbs in the reflectors that point straight down on the chronometer in order to get a consistent amount of light for the sensors on the chrono to work reliably. There is also a photo of the remote chrono display for these aging eyes.

My semi-indoor test range

Close up of the pellet trap and targets used

Front view of trap

Rear view of trap

Close up of chrono display, printer etc.

[OleTomCat]

Jose,

Welcome to our Addiction.........

[amb5500c]

Welcome to the GTA.
Richard