HW 13MM Factory Scope Stop

[TimmyMac1]

I have a few of these from the ARH days. The quality is off the chart. These were made by HW and were distributed back in the 60-70's by Air Rifle Specialists. I bought them from Beeman who bought all the ARH parts at 2 cents on the dollar and then charged retail. What a guy. The lock down nut is the same one they used on the HW peep sights from that era. These are NON-Standard scope grooves that measure roughly 13MM Max width at clamping groove and these stops fit the early guns grooves perfectly and the lockdown screw goes into the factory scope stop hole.

I only have about 6 pieces but how often do you see an HW with that groove width? I think I've seen a half dozen in my life.

http://www.mac1airgunshop.com/product-p/hwerscst.htm

TimmyMac1

[robert w]

are they made to fit my hw-55 made in 1969? i was messin with it when i put a new seal on the piston [original seal died leather ] and noticed the sight was a different width than a newer gun . i don't think mine is 11 mm or 3/8"

[TimmyMac1]

are they made to fit my hw-55 made in 1969? i was messin with it when i put a new seal on the piston [original seal died leather ] and noticed the sight was a different width than a newer gun . i don't think mine is 11 mm or 3/8"

I think the HW35 and 55 both used it.

TimmyMac1