Leaking Prod 😪

[ogre8472]

So over the week I thought I would have a chance to shoot some pests. But with a sales schedule and other things needing my attention it never had a chance. However in doing so I was able to notice my prod drop 1300 psi or so.
I am not about to tear down my favorite pcp with no knowledge of her working (seen to many accidents without proper training). Any recommendations on where to send her for diagnosis and repair?

Thanks all.

Gerry

[Rico14]

Check the air guage. It might be loose. If you take it off put some Teflon tape on it when you put it back in. If you want to send it out , search for Ronnie Easton. He's in Sacramento

[mtbdrew]

Disco started doing the same thing. Turned out it was the fill port. Just needed cleaning and a little polishing as well as a new o-ring.

[Rico14]

The easiest way to check the fill port is to stretch a small ballon over it. If its leaking the ballon will start to fill

[Rescue912]

Mine always starts leaking around the gage. Degas it, retape it and see if that does it.

[ogre8472]

Thanks all. I will double check the purchase date and go that route if possible. I would rather Crosman repair it if possible. The gauge would be possible and I will check to foster fitting tonight when I get home.