I need a part? Started a strip down for a Vortek kit in mail D48 T01 rifle

[TOM aka critter99]

Anybody have one of these around? I'll bet its been busted since the guy bought the rifle. Anybody making these from aluminum or steel?

[Mark 611]

good luck findin that! try some epoxy, I'm sure if you look around you'll find one try TW Chambers airgun spares they might have that part!

[Mark 611]

Tom it looks like they got that part!

[TOM aka critter99]

out of stock there

[Kailua]

Is it cast aluminum?  If so looks like it can be TIG welded.

[TOM aka critter99]

Nope plastic 

the inserts too big for the hole it most likely was broken at factory in 1994

[Mark 611]

http://www.gunspares.co.uk/shopaddtocart.asp is this the part?

[tjk]

If you have small drill bits, try 'pegging' any thick areas of the part and as Mark mentionnEd, try some epoxy type adhesive. JB weld was the first thing that came to mind when I first saw the pic you posted. You can even trim it with a dremil tool once it sets and cures. Have you tried Umerex for the spare part? PA may have them in stock. It's worth a phone call to their technical support line.

[VAFarmer]

Tom,

What....not gonna try Umarex?

 

Just taking a friendly jab, no harm meant.

Could check with Mike Melick.....the B-21 or B-30 part might fit.....

God bless,

Farmer

[tjk]

Lol's!!!! Good idea on the chi-clone part. If anyone would know, it would be MM. Super guy indeed!! Hope he can help you. I'm sure he'd give it the 'ole college try.

[Kailua]

The pin and jb weld idea sounds good.  May be couple of small machine screws and tap in threads.  Cut the head off the screw and hacksaw a slot for a small screwdriver.  Good luck

[TOM aka critter99]

An air gunner had one as he got one of the aftermarket brass ones and is sending it to me *_*

some big hearts out there 

[Kailua]

Yeah that was great gesture.  Best wishes to both of you