Torque setting for Diana 34

[GS2]

What stock torque setting are you using for a Diana 34 with a TO6 trigger assembly.

[HectorMedina]

What stock torque setting are you using for a Diana 34 with a TO6 trigger assembly.

It depends on the screws and the bases you provide for those screws.
I ALWAYS glue with CA a flat washer at the bottom of the fore end screw wells.
Then replace the screws with Allen headed ones: button head for the fore-end, flat head/countersink for the trigger guard/rear screw, then replace the star washers with Nord-Loc washers.
You can then screw those two front ones at around 25 in-lbs.
The rear screw will need to be tuned to the pellet and the power.
Torque it to 30 in-lbs and then release the screw by 1/12ths of a turn (its half one side of an Allen wrench) shooting groups along, you will find there is a sweet spot where the groups are really good. Shoot at least 3 X 10 shot groups in this process.

If you don't want to do all this, then limit the torque to about 15 in-lbs and use some good blue Loc-Tite or Vibra-Tite. Your call.

HTH, keep well and shoot straight!




HM

[GS2]

Thanks again Hector.

[HectorMedina]

You're welcome!

HM