HW97 Stainless Finish Syn thumbhole 20 cal

[TOM aka critter99]

So far I like it alot just abit of twang but its still new and needs break in

[Mark 611]

nice critter getter their Tom

[grumpy]

Looking good !

[crayfish]

So you've finally got it  . It looks nice. When you have some other photos and photos of groups, show us.

[0351_Vet]

Looks great.....Was that anodized or powder coated? Looks sweet.

[TOM aka critter99]

looks to me to be some kind of electro plating

[0351_Vet]

looks to me to be some kind of electro plating

Was this purchased this way? Or did you Mod? Looks great either way. Giving me some ideas.

[TOM aka critter99]

thats a factory model now under both tye HW and Beeman branding

[TOM aka critter99]

fewer than 100 pellets down the tube...mild twang in the rifle but it does not seem to affect POI with such a short barrel and short locktime. All the pellets had a nice snug fit with the CP the tightest at breech, then JSBs, and the HN and FTS with a nice small amount of resistance to seat them.

I am going to waste a 500 shot Tin of JSBs and see if it seats the seal in at all

The tape from AOA was the same JSB pellets and must have had some dieseling...I have been keeping the rifle standing in cabinet on butt so any oil will move away from seal area

AOA JSB
793
699
698
685
680

CP
629.5
629.4
639.0

Beeman FTS
718.3
716.8
716.0

H&N FTT
715.5
718.1
717.7

JSB
652.4
650.3
646.8

[Mark 611]

Tom thats about right for an out of the box rifle!