Collapsible target stand.

[Insanity]

I found this on thingyverse one night while looking for easy to port target stands. I had stipulations on ease of setup and tear down and not set on 3d printing. Actually I was looking to just buy something off of the likes of that jungle store. 3d printing didn't enter till later in the night with the hey lets have a look. I printed in PETG at 30% infill and they feel heftier than I thought. I test fit the 1x2 firin strips and they fit nice and easy. Would I recommend you print one out? No well unless you are ok with a 40 hour total to print time for both parts but there is a link below. I did one at a time and lort I think I could have had a steel base delivered quicker.

All in all its very well designed and has some clearance allowed for that cheap lumber you can get at your favorite home improvement store. There are holes for screws. I like that I can break everything down into a bundle of lumber and 2 brackets. Said setup is light so that's nice for hoofing it to the yardage you desire in one or two trips total, yaknow stand and target. A bundle of 6 1x2 is inexpensive and really the legs and divider should last for ever and uprights you have a few the choot up.

https://www.thingiverse.com/thing:5448274