Need Help finding drawing female paintball receptacle

[oldpro]

 anyone have a drawing of the receptacle for a paintball regulator with pin height etc. etc.

[aluminumfetish]

The pin height on one of my drop adapters is .120 "- .121" Measured with an import digital. I will see what the pin height is on my AF C02 adapter. The pin height on the AF adapter is .080" and the pin diameter is much smaller but it is streel versus the aluminum body on the QB79 drop adapter.  Can't really get anything in there to measure the diameter on the pin but the aluminum pin is about .125" and the steel pin is about .120" dia (very crude measurement. The drop adapter is .608 deep and the steel AF adapter is .618"-ish deep. On the generic QB79 drop adapter only about the top .260" is threaded. The AF adapter is threaded about .360 deep. I can sketch it up quick if it helps.

If you know what that thread pitch is and it's in the Fusion 360 library, I can model it up and send it to you. I miss GRABCAD.

[aluminumfetish]

This is after a 6pack crude drawing.

[oldpro]

This is after a 6pack crude drawing.

Thank you !!!

[Tucobenedicto]

Found this on my pc.

[aluminumfetish]

Tuco... that drawing is GREAT !! I am going to model a male and female in Fusion360 from that drawing this afternoon. My skills are not good enough to recreate that drawing but I can capture the important bits.

[Tucobenedicto]

I made a dropblock for my Prod from those specs and it worked fine.

[oldpro]

Found this on my pc.

 excellent