Benjamin trail np pistol converstion

[Mascot01]

Was just curious if anyone has tried modding a benjamin trail np pistol to carbine or even if there's a way to convert to riffle?  I've seen a few videos where people have added a stock but no details on how to. Have been curious on what would be needed to convert it. Any thoughts or advice?

[gloob]

One of the top Amazon reviewers posted pics of his. It looks like he just chopped a 1399 stock and epoxied it to the grip. There are putty epoxies that are easier to work with when built up a lot. Then grind/sand down and paint.

I've seen another mod where a dovetail to picatinny adapter was used as an attachment point for a stock. That doesn't leave much room to attach an optic, though.

In my Trevox, the gas ram is backwards. I mean, the air cylinder rides mostly inside of the piston, and the arm is in the back. So there is potentially a lot of room and opportunity to drill and tap the rear inch and a half or so of the cylinder, if you wanted to go that route. The steel plate that holds the arm of the gas ram at the back is another potential hard point. If you attached a nut or bolt to it, and fit it nicely through a hole in the plastic plate that takes the pin, you could screw a wire stock into that.

Getting a pistol back together is really hard, FYI, without a spring compressor.