RWS 350 Feuerkraft 22

[WHITEFANG]

I got the compressor. How hard is it to take the barrel off the gun. ANY TRICKS that I should know about? And anything I need to know about on the otherend?

[TOM aka critter99]

I don't have a 350 but it should basically the same as a 34.

have the barrel partially broke open to remove pivot bolt or you will be fighting the detent spring!!!!

Best advice (GOOD SCREWDRIVER BITS!!!!)  I use a handle thats takes bits with 1/4 hex shanks if I get one thats too tight I can slip a 1/4 box wrench on the shank of the bit to turn it and then lean in on the driver handle ....so far no damages any fastners *_*