Foster quick connect

[KenH]

Hello - can anyone provide a link/source of the Foster Quick Connect adapter for the Mrod?  I'm getting ready to order the Mrod, I have tanks and yoke/hose.  BUT - I will need a connector to put air in Mrod (my understanding anyway).

Also, what threads will the Foster quick connect have?  BSPP or NPT?  1/8" or 1/4"?  Male or female?

Thanks to all for good suggestions and help over the last week.

Ken H>

[KenH]

It's all the fault of GTA group!!!  I just placed the order for the Mrod and a foster fitting for my tanks.  Sure looking forward to getting it here - I've got a scope and rings to mount so I "hope" I'm ready to go.

Thanks again to the group for all the help and guidance,

Ken H>

[rsterne]

The MRod has a male Foster, so you will need a female Foster fitting to connect to it.... All the commonly available ones in the USA have 1/8" NPT female thread, although I have seen some with male thread.... Don't buy an "unrated" paintball fitting, get one rated for at least 5000 psi.... Likewise, if you have to use a male-male adapter, get a steel one, or if brass, make sure it has a thick wall and is rated for the pressure required.... Gas line fittings are NOT good enough....

Bob

[KenH]

Thanks for info Bob - Airguns of Az is where I ordered the Mrod, and they said they have the correct fitting to fit the Mrod - it's got the 1/8" BSPP thread so I'll have to rig up an adapter from 1/4" NPT to 1/8" BSPP.  Shouldn't be too hard - if needed, I can tap the 1/8" threads into something.  I've got a decent set of taps.

Ken H>