Need some measurements please

[2K1TJ]

Does anybody know the length from the rear of an Mrod tube (not the end cap, just the tube) to the front of the valve, and also the distance from the rear of the tube to the front of the gauge block? Gen 2 if it matters. Doesn't need to be a caliper measurement, a tape will do fine.

Thanks!

[FuzzyGrub]

With some extrapolating, I get 5 13/16" to front of valve.  The gauge block sits right against the valve.  Add 1 7/16" for it.

That is a Gen 2.

[2K1TJ]

Thank you, sir!

[Crosman Engineer]

John you are really close!  The CAD model shows 5.84" from the back of the tube to the front of the valve and 5.854 from the back of the tube to the front of the gauge adapter (against the valve) and 7.320 to the pressure side of the gauge block.

John

[2K1TJ]

John you are really close!  The CAD model shows 5.84" from the back of the tube to the front of the valve and 5.854 from the back of the tube to the front of the gauge adapter (against the valve) and 7.320 to the pressure side of the gauge block.

John

Always nice to see somebody from Crosman on the Forum! Thanks for the info.
I would ask to see the CAD drawings, but I'm guessing you aren't allowed to share them.