BSA/Gamo Valve

[Eddie_E]

Does anybody know if the the Buccaneer/ Urban valve body seals with white delrin directly against the brass valve body or does it have an O-ring? I had a leak through the barrel after my Huma Regulator install.

 I'm replacing the super small 2mm x 4mm O-ring on the hammer side of the valve shaft and I'm wondering if there was a missing O-ring before the TP or if I just got some dust in the valve.

[rgb1]

You are not missing anything......the seal is accomplished
with a polymer valve against the brass valve body.


                                              Ron

[Eddie_E]

Thanks, I think I got it now. It turned out the fill port was also seeping a little. That was the only part I didn't touch last time around.