Do You Cast .22 or .25 bullets or pellets?

[Glem Chally]

I just received the official NOE drawing for this bullet.... It looks like it should be proceeding once Al has everything back up and running full steam, which he says will be in a couple of weeks....

Bob

For which bullet? Hopefully .25 or .22 HP.

[rsterne]

(as in Reply #29)....

Bob

[triggertreat]

It would be great if one of you were able to test the .252 in a GM choked barrel or similar.  I already dove in on the 252-41 BBT, but had no joy.  This one looks similar without the BT.

[Glem Chally]

(as in Reply #29)....

Bob

Sorry was on my phone and couldn't see where they're numbered but see it now.  Thanks,  I'll pick one up for sure.

[Kinetic45^]

I've checked the .251 size at NOE regularly to see if this bullet ever turned up but have never seen it. Or waited to maybe seei a new post here saying available.
I was working with Al at NOE on other bullets but not this one, it was more rsterne communicating with Al on this one I thought.

Honestly, I saw a need for the community based on my shooting experience, but I've moved mostly into 7mm and .357, so much so that my .25 guns are all sitting idle and I've even considered selling them. (Except my 130 FPE .250 FLEX but that shoots heavy 50gr bullets)

If the community wants this bullet/mold someone (else) is going to have to light some fire to get it manufactured.
I would still buy one if it became available though.

[Wayne52]

It would be great if one of you were able to test the .252 in a GM choked barrel or similar.  I already dove in on the 252-41 BBT, but had no joy.  This one looks similar without the BT.

Keith the 250-41-FN's are too tight in my Mrod with a GM barrel, I can chamber them but they really need to be sized down about a thousandth.

[triggertreat]

It would be great if one of you were able to test the .252 in a GM choked barrel or similar.  I already dove in on the 252-41 BBT, but had no joy.  This one looks similar without the BT.

Keith the 250-41-FN's are too tight in my Mrod with a GM barrel, I can chamber them but they really need to be sized down about a thousandth.

Thanks Wayne!  Yea, I've sized them down to .249 so far.  I need to work on the leade some according to other member's input here.