.25 Armada

[oneshot61]

Just for kicks, I put my no bounce war hammer in, filled to 3k . 43.2 @ 960 FPS. Bbt 48 grain hp @ 915. Was not expecting that. I had a 1/4 gap between hammer and valve. I’m going to a 64.7 mds hammer to keep from dumping air and flatten the string for a mag. Hopefully tomorrow.

[KnifeMaker]

Gotta Love it! The spring you sent , with only one and one half turns in, gave me over 91 fpe.    


Backed her back down as it only got 5 shots at 90+ fpe before poi changed.  She now gets a full mag of mid 80's fpe. 


Knife

[oneshot61]

Wow! That’s awesome! Got to love that rainstorm. Even at 5 shots that’s a coyote smack down and plenty shots left. I’m going to settle mine back down mid 60’s again since I have the rainstorm .30. I installed a jsar depinger and it took all the ping out of the armada. At 65 ft lbs with a mds hammer it’s really quiet.

[KnifeMaker]

Humm, I wonder if they have anything for the RS. Some similarities to the Krals.


Would love one of their Valves, alu. tubes. 


I'll bet 100 fpe is not far away with this .25 Storm. 

[KnifeMaker]

Wow! That’s awesome! Got to love that rainstorm. Even at 5 shots that’s a coyote smack down and plenty shots left. I’m going to settle mine back down mid 60’s again since I have the rainstorm .30. I installed a jsar depinger and it took all the ping out of the armada. At 65 ft lbs with a mds hammer it’s really quiet.

Wait, they already have a depinger for it?

[mackeral5]

Are these springs for sale? My interest is up, I'd like to get my hands on one to try in one of my contraptions. 

[oneshot61]

Humm, I wonder if they have anything for the RS. Some similarities to the Krals.


Would love one of their Valves, alu. tubes. 


I'll bet 100 fpe is not far away with this .25 Storm. 

There is a possibility their kral  depinger will work in the rainstorm. I didn’t realize they had it. I got one from Will Piatt but haven’t had time to install it.
With a 48-50 grain bullet I have no doubt you can get 100 ft lb.
 As soon as I master the dual wire spring making ( Tim makes it look easy) I’ll get one to you.

[oneshot61]

Are these springs for sale? My interest is up, I'd like to get my hands on one to try in one of my contraptions.

I bought mine here:
https://www.amazon.com/gp/aw/d/B005KV0UD6?psc=1&ref=yo_pop_mb_pd_title

[KnifeMaker]

If I  tried such a thing, I can just hear it now.  Spoing!!! and the hunt is on. GRRRR!