New Slavia 634 shooting left

[Alanheal]

My CZ Slavia 634 arrived today. Nice rifle, light, powerful... .BUT it's shooting to the left. I adjusted the windage as far as it would go, until it stopped. At that point,  the pellets were finally on target. However, if I ever need to adjust for windage, there's no where to go.
I passed a Bore Snake through it and shot about 50 pellets.  I've tried pellets ranging from 6.48 to 8.80.  Any suggestions?
 

[hutnicks]

I'll start off with the usual suspects. Check the tightness of all screws particularly the breech fitment. Have a close look at the barrel crown and make sure there are no anomalies visible.
Check the barrel for alignment to the centreline of the rifle. Not unheard of for a barrel to be slightly bent.

[flyer]

I'll start off with the usual suspects. Check the tightness of all screws particularly the breech fitment. Have a close look at the barrel crown and make sure there are no anomalies visible.
Check the barrel for alignment to the centreline of the rifle. Not unheard of for a barrel to be slightly bent.

         I would emphasize the possibility of a misalignment between the barrel and the main cylinder focused in the area of the breech jaws.

                 The breech jaws may be wrongly cut causing the problem (wrong angle).

         Take a careful look on the front sight also - it may not be in the right position (exactly at the middle of the barrel end - on the same vertical axis with the barrel exit).



         

[PIPERMAN]

First check front sight if it's in place.
Then check if there are washers on both sides of the barell's block where it connects with breech jaws.
Nice gun,hope you enjoy her

[Alanheal]

Thanks for all those suggestions, which I checked out one by one. Couldn't find any reason for the problem. I just wrote to company in Czechoslovakia. If they can't suggest a fix, I'll exchange it for another one.