well I guess I'm gonna be the ginnie!

[Mark 611]

it says the site is an un trusted site!

[Booger]

it says the site is an un trusted site!

I guess the site knows who to trust and NOT TO TRUST. LOL

[aack73]

it says the site is an un trusted site!

if it is i'm sorry. i have used it before, but not to say if it is or isnt. cause i dont know.  

[Mark 611]

well I've been shooting the PS a little since installing the setup from JM, I have also done some changes to the breech seal  and no Scott I have not blown seal LOL!!! but I don't like the double  o-ring  set up PITA so I have a friend who has used this set up glassman98 , so here's what I did, I used a Vortek  HW breech seal the one Tom makes not a factory seal! Tom's are allot harder and that's what is needed for sliding compression tube rifles! I think his current lot are black? the one I have is red but I've had it for a few yrs anyway I used a 30 thousands shim under the seal and it has a nice feel when closing up the breech it a little stiff to cock but getting better hey its new! but the shot cycle is smooth as silk and very quiet! the velocity is on par with the factory set up I took out of the rifle aving 710fps thus far, it takes 2 midots for 60yd shots and it right on the money! I'm shootin maple seeds off the ground at that distance with ease! I highly recommend this kit for .22cal rifles

[Booger]

Thank you for the report. You make it so I can hardly wait until I get my rifle back from the tuner. I only have one or two rifles ahead of me, but it feels like 10 or so.

[palonej]

Ok Mark!! Sounds awesome.....can't wait till my spring breaks!!! Lol!!
On to the important part of this reply. I let you be an unofficial guinea for a couple of weeks......the time has come for you to give up your guinea status sir. Sorry.
 

[Dockey 454]

Thanks for the report Mark. Been trying to decide what kit I wanted to try.
Tom

[Hanabata808]

...I don't like the double  o-ring  set up PITA so I have a friend who has used this set up glassman98 , so here's what I did, I used a Vortek  HW breech seal the one Tom makes not a factory seal! Tom's are allot harder and that's what is needed for sliding compression tube rifles! I think his current lot are black? the one I have is red but I've had it for a few yrs anyway I used a 30 thousands shim under the seal and it has a nice feel when closing up the breech

Hey Mark... quick question about the breech seal. I have 1 left over spare HW breech seal from Vortek (black HW-BlkOP).  I'd like to install it in my TX200 mk1.  That's great news that you can use that particular HW seal in the TX.     What are you using for a 30-thousands shim under it?

[Mark 611]

well I used a piece of copper wire! that way I can shape it anyway I want you can make an outer an inner ring to fit your breech

[Mark 611]

sure Joe you can have it now!