Off Season 10M Casual Match #9 Year 22/23

[avator]

Wow !! I would be inclined to frame some of these targets and hang them in my mancave.

[MartyMcFly]

Rifle:  Air Arms S510
.  PCP Class
.  Shot @ 10M
.  Rested F/R
.  Scope:  Hawke @12 power
.  Pellet: .177 RWS R10 Match 8.2 gr
.  Shot at lowest power setting (UNK FPS)
.  Score: 200 / 17X

Shoot well and enjoy!!   //Charlie

Those are some nice clean holes with the R10s. I may need to get myself some. Nice shooting!

-Marty

[Firewalker]

False alarm on the compressor, AFTER I tore it apart and reassembled it. Turned out it was an oring on the filter.

Here is my card for this week:


Rifle:  JTS Airacuda MAX
.  Firewalker
.  PCP Class
.  Shot @ 10M
.  Rested F/R
.  Scope:  Alpha 6 4x27x50
.  Pellet: CPHP .22
.  850 fps
.  Score: 200/200/13X

[Hoosier Daddy]

Nice job all!
 I shot one but didn't get it submitted on time.

I'll get match 10 going tonight.

[KB7PYF]

Thanks Marty, I kinda cheat. I am using cheap card stock from Walmart and then use practice targets as a back so they're stiffer which usually turns out a nice crisp cut. You sir shot a nice card.

I need to get my tx200 going. I got it apart can't get it back together. I've bought two springs kits to change out and lower the foot pounds of energy and now I can't get it back together. I don't want to, but I think it will have to send it off.

[MartyMcFly]

Thanks Marty, I kinda cheat. I am using cheap card stock from Walmart and then use practice targets as a back so they're stiffer which usually turns out a nice crisp cut. You sir shot a nice card.

I need to get my tx200 going. I got it apart can't get it back together. I've bought two springs kits to change out and lower the foot pounds of energy and now I can't get it back together. I don't want to, but I think it will have to send it off.

When I change my springs I put a towel on the table to prevent it from sliding about and use my body’s weight (gun vertical) to push the trigger group into the compression tube and then fix the holding screw back into place. It shouldn’t be too bad if you get some thick towels to prevent it from moving around. Just make sure that the kits you are using don’t require the removal of the top hat that goes into the piston body, that may prevent you from getting it back together as the preload will be too high.

-Marty

[avator]

Thanks Marty, I kinda cheat. I am using cheap card stock from Walmart and then use practice targets as a back so they're stiffer which usually turns out a nice crisp cut. You sir shot a nice card.

I need to get my tx200 going. I got it apart can't get it back together. I've bought two springs kits to change out and lower the foot pounds of energy and now I can't get it back together. I don't want to, but I think it will have to send it off.

Check the member's map and see if anyone is close to you... GTA members are normally happy to help out another.