What to do with a left over P-Rod tube?

[FuzzyGrub]

fuzzygrub -

maybe this link will work?

For the BB gun conversions, used stainless steel hose, but was very short.  I never found a pressure spec on it though, just the "paintball use" statement.  Which I am assuming is probably good to 1500psi or so.  I have the regulator set for 850-900psi with a lower pressure burst disk.  I did try the plastic macro hose, but in short lengths and for my use, had to many leak problems. 

Using the asa adapters, I can go from a gun mounted tank to a belt mounted tank with a fill hose.  I also use it on a P1 pistol. 

The paintball stuff, I'm still a bit leary of using at 2-3Kpsi.  If I decide to bottle a 7/8 tube, probably will try to get a gaunlet drop block.

Many ways to configure Prods/1720T/1701's.  It was my main obsession for quite some time.   

[TheOtherSprocket]

The paintball stuff, I'm still a bit leary of using at 2-3Kpsi. 

I've found some tanks come with an 850 psi output.  And there are regulators that you can buy separate as well.

[FuzzyGrub]

I wasn't
The paintball stuff, I'm still a bit leary of using at 2-3Kpsi. 

I've found some tanks come with an 850 psi output.  And there are regulators that you can buy separate as well.

The regs and bottles was not the issue.  Back when I was considering a similar build, the ASA adapters were all low pressure, and the hose rating not known.  Don't get me wrong, the Prod can probably do allot with a reg output of 1100-1200psi.   I was looking for something higher at the time.