Red/Green Reflex Sight on Benjamin 392S...

[mrbulk]

...only because I can't get a scope to fit perfect so far (perfect as in not only seeing thru scope properly, but being able to more easily pump it up to ten times with mechanical efficiency).

Also the clacking of the pump arm, like some have said they laid something down between tube and pump arm. But the clacking is also partially caused by the outer plastic edges of the pump arm so I had to extend the (hooky side of) Velcro patch by widening the taped area (had to apply double width).

[wll2506]

...only because I can't get a scope to fit perfect so far (perfect as in not only seeing thru scope properly, but being able to more easily pump it up to ten times with mechanical efficiency).

Also the clacking of the pump arm, like some have said they laid something down between tube and pump arm. But the clacking is also partially caused by the outer plastic edges of the pump arm so I had to extend the (hooky side of) Velcro patch by widening the taped area (had to apply double width).

I know that mount well, what would happen if you turned that mount around and set the DOT a bit further out so it would be more like a scout scope set up - that way you would have more room for your non pumping hand on the receiver and would leave the loading port open for loading.


wll

[mrbulk]

...only because I can't get a scope to fit perfect so far (perfect as in not only seeing thru scope properly, but being able to more easily pump it up to ten times with mechanical efficiency).

Also the clacking of the pump arm, like some have said they laid something down between tube and pump arm. But the clacking is also partially caused by the outer plastic edges of the pump arm so I had to extend the (hooky side of) Velcro patch by widening the taped area (had to apply double width).

I know that mount well, what would happen if you turned that mount around and set the DOT a bit further out so it would be more like a scout scope set up - that way you would have more room for your non pumping hand on the receiver and would leave the loading port open for loading.


wll

Thanks for the reply wil, after I got it mounted up and tried it out it turns out the red dot was quite a bit still too high, so I did go with a scout setup except with just a long eye relief 2.5x scope this time, will be trying it out soon (we are in super hot Vegas weather at the moment plus I just had some eye surgery done) but soon. This is what it looks like with the scout scope and also with the Froggy's 1/2"-20 LDC adapter, already shot it indoors w/a Sumo @8 pumps and it was quieter than bare barrel at 2 pumps...