Ninja regulator creeping

[bear air]

Hey guys I just topped my 30 cal bottled armada and I noticed the secondary gauge was around 32-3300. Its a fixed ninja regulator that's supposed to bet set at 2600. Any ideas on whats going on here? And any suggestions on how to fix it and make it right again? TIA. Getting to be shooting season again and I want to get a fair amount of shooting in with this rifle this year.

[nervoustrigger]

If it’s creeping, check the valve seat.  It’s probably indented and worn. If it’s the plastic ball type like most (all?) Ninja regulators, you can pop it out and reverse it to get a fresh surface.

I’ve started using Delrin replacements with good results.
https://www.gatewaytoairguns.org/GTA/index.php?topic=179050

[Motorhead]

Yup .... the weak spot of adopting a High recovery rate regulator from the paintball industry to be used in a precision air gun.
Many of us redo the seat material to get them to creep less 

[RDB]

This kit will probably get you up and running.

https://www.hustlepaintball.com/Ninja-Paintball-Regulator-Rebuild-Kit-Fits-all-N-p/11210801.htm

[bear air]

Thanks guys.