CP2 gets a big upgrade.

You might notice the bolt on the left side. This is actually the receiver from the CP1/CP2/PP800 carbine I've been tinkering on for NV/Camera (ATN X Sight HD) gun. I swapped it out with a right hand receiver which is better suited for the carbine. It's also fitting that the right hand receiver is from a "Varmint" and is stamped as such.
So that gun pretty much named itself... "Varmint Gitter".

We're just having all kinds of fun here in the Red Shed.

I found a small screw and tap with the same thread. I don't know the size because I can't see things that small. It was easy to rethread the hole. The screw is just a shade too long but I think I'm going to leave well enough alone. Basically it just a 'lego' and more likely than not it will be a donor for the next must have idea I come up with.

I would have just broke it back down into parts but I didn't even get to shoot it yet.
That will happen tomorrow.

That's pretty sweet James. Bottled guns are one thing I have yet to tinker with. Maybe I should look into it for my next project. The subject gun of this thread may just be a right candidate.
That would be a great story to track the journey of this CP1 all the way through C02 to a bottled regulated HPA carbine.