Benjamin Akela/Cayden/Kronos SSG

[TroyHammer]

Hopefully over the next few weeks I'll get the testing finished.  I have 12 different spring options to work out.

[TroyHammer]

SSG top vs factory spring bottom.

[Motorhead]

Good news that an SSG can be successfully fitted .... While they lack broad range adjustablity, if you know the power wanted there the BOMB !!

[Hangtown-Shooter]

Interested! 

[TroyHammer]

Good news that an SSG can be successfully fitted .... While they lack broad range adjustablity, if you know the power wanted there the BOMB !!

Takes a little work to fit it but should be a  perfect match to a reg.  Hopefully a reg that fits the Benjamin guns comes soon. A twin spring for the un regged guns should be an easy fit as well.

[smythsg]

Following... just ordered an Akela .22 cal.

[mrbulk]

Following... just ordered an Akela .22 cal.

Steve, I just joined the Akela club too. Can you tell me about how long yours took to arrive from the date of order?

[smythsg]

Hi Charlie, mine arrived a day earlier than it was supposed to. If I remember correctly, I ordered it late on a Friday afternoon and it showed up on Wed the next week.

[rkr]

So this is an Evanix clone but it does not have RVA?

[TroyHammer]

So this is an Evanix clone but it does not have RVA?

Valve is a clone but the hammer,  breech, trigger and the rest of the gun is different. It does have a RVA well a rear hammer spring Tensioner screw.

[mrbulk]

Hi Charlie, mine arrived a day earlier than it was supposed to. If I remember correctly, I ordered it late on a Friday afternoon and it showed up on Wed the next week.

Hey Steve, tomorrow is Wednesday ... so I have hope...

[KnifeMaker]

The hammer looks identical in your pic to the RS II I have. Perhaps different dimensions?  Speaking of which, I wonder if the HUMA Reg for the evanix gus will work in the Krals. Is tube bore the same size?


Knife

[TroyHammer]

The hammer looks identical in your pic to the RS II I have. Perhaps different dimensions?  Speaking of which, I wonder if the HUMA Reg for the evanix gus will work in the Krals. Is tube bore the same size?


Knife

It's a very similar hammer. Same length and outside diameter but uses a cocking lug on top instead of the machined slot and a smaller hole for the hammer. it also has a flat machined in the bottom that acts as the sear engagement rather than the front face. The tube ID is 30mm so the same as the Kral and I suspect the same as the Evanix. The threaded depinger cap isn't the same as the kral so neither the Huma that threads in or the lane that seals against the depinger cap will work without modifications.

Here's what it looks like.

[KnifeMaker]

The hammer looks identical in your pic to the RS II I have. Perhaps different dimensions?  Speaking of which, I wonder if the HUMA Reg for the evanix gus will work in the Krals. Is tube bore the same size?


Knife

It's a very similar hammer. Same length and outside diameter but uses a cocking lug on top instead of the machined slot and a smaller hole for the hammer. it also has a flat machined in the bottom that acts as the sear engagement rather than the front face. The tube ID is 30mm so the same as the Kral and I suspect the same as the Evanix. The threaded depinger cap isn't the same as the kral so neither the Huma that threads in or the lane that seals against the depinger cap will work without modifications.

Here's what it looks like.

Humm, my rs II has no depinger cap. Looks much like the Kral. I'll bet the huma which simply seals against the wall with the threads with an o ring would work just fine.


Mike