Looking for a .25 Cast Bullet Mold For AF Condor

[Loren]

The new molds and sizing dies arrived and I did some quick casting with them.  The BBT is dropping at 60gr and the

The 260-63-FN-AR4 is dropping right at 63gr

The 253-65-FN is dropping at 60gr.

The Condor is pushing these at 940-950 fps and over 120fpe with both of these, and I haven't done any adjustments yet.  Accuracy is looking pretty good with both and the .253 sizing die looks like the best size. Larger just does not fit in the breech without a lot of force. 

A did shoot a few through the .257 Texan too.  It is pushing them at 1150ish. 

[Bullfrog]

Do you have a .250 sizer? My Condor shoots both .253 and .250 well, but uses less air per shot with the .250.

[Loren]

I do have smaller sizing dies.  I will try size some lots under the .253 and figure out which one does best.