windage adjustable scope mount

[wimpanzee]

My 909s won't let me dial windage in, I think the scope rail might be off a little. Even dialed all the way to one side, its off by about 8" at 25 yards.

The iron sites, I am scared to use, because the rear site wiggles, and I would just prefer a scope...

I was hoping to find some windage adjustable rings or a 1 piece mount with windage adjustment. All I can find are the beeman 1 piece and some millet angle-loc weaver rings. I would prefer a dovetail solution, but I can bolt on some weaver adapters I have if necessary.

Are there some I am just missing somehow? I know most are targeted towards barrel droop, but surely there are more options for windage.

[mobilehomer]

Have a look at these.
http://www.opticsplanet.com/sun-optics-adjustable-airgun-rings-airgun-ring-base-combos.html

[wimpanzee]

oooo perfect! thank you!

[mobilehomer]

Nervoustrigger has created a detail instruction set with great pictures for the install and adjustment of these. Here's the link -
http://www.gatewaytoairguns.org/GTA/index.php?topic=50738

[nervoustrigger]

Thanks for the plug on my writeup.  I just wanted to note a good recommendation that Roadworthy pointed out.  My writeup suggests adjusting the windage first but you may be better off setting the elevation first.  Otherwise if you need to fine tune the elevation by a half-turn, it will essentially reverse any windage adjustment you have already dialed in.  One of these days I'll get around to updating the doc.

BTW, if you only need windage correction, you may want to just shim the dovetail base (the fixed side) with strips cut from an aluminum soda can.  Only do this with a one-piece mount or you'll put stress on the scope tube.

[Bullit]

Many times, you can flip/flop your rings and get better results.  The scopering mounting screws (to the rail), don't necessarily have to be on the same side.  That's extreme to me.
If you didn't hone (called "lapping"),,the rings, prior to installation, you can have an edge, (a sharp edge),  that throws everything off.  Not uncommon.  Then you may see where you have to "shim it".  HTH 
Perhaps try this tact (remove the scope and see if you have scars, then relieve the edges),,,and see if you can "clean it up".

[Rocko]

Millet also has angle-loc windage adjustable rings for dovetail mounts. I have used them & they work pretty well. Available in several heights.