Adjusting Charlie's trigger for the NPSS

[RedFeather]

Can't seem to find the directions for which screw does what.  Also, how far in you can screw that Allen bolt in the front.  If there's a link that describes this, please point me to it.  The installation video is for a pre-set unit.

[fgwhite]

hey red whats wrong with the way it was set i loved it was lite ans had a short pull

[uncle paulie]

When all else fails....read the book! LOL
http://charliedatuna.com/index.html
Download the GRTIII installation instructions pdf.
pv

[RedFeather]

When all else fails, read the post, LOL!  It's not a GRTIII but the one for the NPSS.  The installation video is for a pre-set trigger and doesn't show any later adjustments (that I could see.)  If you know where that link is, please POST it.  I would much appreciate it!

Red

[thekid]

I watched the video of buddy putting the CBR Trigger in.
The trigger assembly is basically the same.
So the Allen key screw would be for FIRST Stage pull
The slot or rear screw would be for the second stage/Let off.
It also shows him removing the spring for the trigger and putting a new spring in.

[RedFeather]

Thanks.  I had that rear screw run completely down flat.  Guess it is what it is.  I see that Charlie said there is an optional lighter weight spring to bring it down further.  May have to go with that.  I appreciate all ya'lls help.

[uncle paulie]

If the rear screw is all the way in, I think its in the wrong place. I would contact Bob(CDT) to get back to the starting place. When adjusted properly, the second stage will be approx. 1/8" back from the starting point, and can be adjusted for preference on length. The "feel" for the second stage is very light and many pass it by until they get it. The first screw adjusts the length of the first stage. Be careful with the adjustments, a little too much and it is possible to get to a bad situation.

pv