RMR mount shim

[WobblyHand]

It seems that for close range, I can't quite get my red dot and POI to line up.  More or less have run out of adjustment.  So I looked around and found that they sell an angled shim for this.  Of course, I didn't want to pony up the $14 they wanted, so I more or less duplicated it, with a reversible mount.  It's not fancy, but hey it's only sandwiched between the red dot and the mounting rail.  Designed a 1 degree wedge, starting at 0.2mm thick and ending up at 0.95mm thick.  Used 0.05mm layers to build up the height.  Didn't take long to print.  I'll check it out tomorrow.

[Ronfiveo]

Good job.
It beats pieces of paper or tape

Ron

[subscriber]

Perfect job for 3D printing.

[WobblyHand]

The holes for the posts (the outer ones) were a little snug, so I opened up the holes a wee bit.  Kind of hard to keep tight tolerance on FDM.  Reprinted it.

Here's the stl.  It's not a big file.  (214KB)  First layer should be printed at 0.2mm, all other successive layers at 0.05mm.  It's only 18 layers so it doesn't take long to print.  On a sample of one, using a Holosun 507C, I could make it work.  Hope it is useful to someone.