Average pcp re seal time and how long do the poppits last

[FlyFisherMan101]

How long on average will a pcp shoot befour the seals deteriate and
Need replaceing and how long will poppits last in a pcp if the air is
Kept dry and clean. This am i pumped up my beni in the furnace room
And at 6am the humidity in there was only at 10 percent.
I have a hill mk5 pro pump with the dryer media on it. Tested the
Media the other day and after two months its still bone dry. I
Found out if you put a little desicant in the palm of your hand and
Then put a drop or two of water on them and they get HOT the
Desicant is still good. Is that accurate..Thanks

[Frank in Fairfield]

Don,
Poppets will go when they are good and ready.😂
I had one go on my PRod so I ordered four.
I had three rifles too (all sold now).
One of those rifles had more than 45,000 pellets fired.
No more poppets failed.
You know how it is?
When your are prepared for something, it never happens.
The same for the seals.
Good luck.

[Motorhead]

On o-rings for a NON regulated ... 5-8 years, on a Regulated figure 3-4 tops.

Poppets are VERY varied as some guns and there seat design may vary seldom to never fail, others such as Crosman have a higher failure rate.

[FlyFisherMan101]

Thanks Frank and Motorhead im sourcing spare parts for my bengamin cayden in
22 i will also order a couple poppits for it at same time as i think they are made of nylon

[Madd Hatter]

As far as the avenger it also depends on which poppet you have. They changed the poppet I believe last year to 1 that will last longer than the first one they used. You can't really think age but number of shots and how high the regulator is set. The higher the pressure the more wear.

[PickleFart]

I had a poppet on my gauntlet .25 go bad after a week, put a hajimotot one in because I didn't have a lathe yet to make my own. His poppet has been just fine after 1000 rounds and more dead trash bandits than I can count.

[Back_Roads]

 I have PCPs made in 2014- 15 still working perfectly, but I know any day that may change. Most of my leaks were with new Benjamin Maximus way back when the guns were new and under warranty. OR self induced from tinkering.

[FlyFisherMan101]

Great info from a great bunch of folks thanks again everyone