Bengamin Cayden in 22 cal oring sizes and velocitys

[FlyFisherMan101]

Hi does anyone have any info on the oring sizes for the Bengamin Cayden in 22 call
As specialy outer barrel o rings power adjuster transfer port o rings breech pellet probe
O rings and all the other o rings in the tube. As well what are realistic velocity’s from
The differant pellets at full power and full fill with this rifle a big Thankyou to anyone
Who can offer advice

[jus Tom]

Can't help with oring sizes... but velocities I can, along with excellent accuracy @ 50yds and 50+ shots per fill.

JSB 18.1gr - 920fps @full power
AA 16gr - 935fps @ 3/4 power
JSB 14.3gr - 805fps @ 1/2 power

[FlyFisherMan101]

Thanks my cayden the best i can do with the hammer spring set at 6.5 full turns cw preload
and trans port power adjuster full i get average of 895-900 fps with the 15.89 hades and through
same hole at 25 yards with the jsb jumbo heavy exacts 18.13 grain i get an average of 858-864 fps
and with the crosman hp 14.3 grainers i average 935fps this is only for first 20 -25 shots,i get about
32 full power shots then after that they drop about 20 fps and after 40 shots then im below 4 % from
first shots.My cayden is a little slower that most but very accurate.When i first got it both barrel orings
were nicked and my power adjuster had one oring with a divot out of it as well.maybe there is a small
bur someplace in the valve or something but i will leave it till off warranty. my guage on gun is out 300
psi to the high side i cheaked it with a wika guage.

[FlyFisherMan101]

Oh and crosman canada told me if they send me out the orings to replace the ones
i had to use to fix it and a new guage it would void my warranty thats some kind or warranty
isnt it. And to think i didnt even go inside the gun guess if you need to replace an oring they
expect you to pay $100.00 and send the gun to them? what a joke this is my last crosman anything
im done with them.

[jus Tom]

I must've got a good rifle as I'm shooting mine as it came out of the box. Can't blame you for feeling as you do... but from most of the reports I've read, most fellows are happy with their Craftsman series rifles.

[FlyFisherMan101]

Until a person is the one who gets the lemon you should see the forend the part the cylinder sits in the wood is 1/8th” thick on one side and about 1/4” thick on the other and on the thin side it looks like it’s been filled with something to build it up. Stock only stained and not fishished etc mine is dead accurate though but only average 200fps faster than my weihrauch hw80 in 22 cal another tack driver after I got done with it

[Trucker3573]

I have no experience but I can say I’ve read about a lot of displeasure when it comes to support etc from Benjamin. Seems a 5 year warranty sounds good on paper but may not be so straight forward and simple.

[FlyFisherMan101]

You are right about that trucker at least it’s been my experience so far I’m hopping beni
Will prove me wrong they wanted me to send in my rifle that would cost me another 100
Bills but I got her shooting sweet now after all the replaced damaged orings . The gauge is
Still out 300 psi on the high side and they won’t even let me replace this so I will just order
A wika and put it in