Air Venturi has set the bar for inexpensive top notch PCP with the Avenger !!!

[JimD]

I put a CARM magazine of pellets through my Avenger today into my new swinging target.  The trigger is surprisingly good, especially since I was also shooting my newer P35 which I have messed with at least as much as the Avenger and it is still a bit heavier than I would like.  No misses with the Avenger, I had one with the P35.  It's definitely a shooter (but not a looker IMHO). 

CARM's magazine for the Avenger is definitely better than the stock one, by the way. 

[avator]

I have 6 stock mags for my Avenger.. other than one fitting a bit tight, no issues as of yet.
I've got my gun set to run the 6 full mags for one fill at 2100ish psi. That nets me 40ish fpe with the Benjamin domes (I think 25.8?)
Again, cheap guns efficiently shooting cheap pellets accurately. I can't ask for more.
As for looks.... I have yet to have a dead critter complain...     Maybe because it stopped to look at it too long.... lol

[buddyb]

I brought my .22 avenger up to 42fpe with FX 25.4 pellets and an avg fps of 867, HS around 3.5-4 reg at 2700. I stopped there and sighted it in to 50 yards. Walnuts didn't stand a chance lol. I hope to get out squirrel hunting later this week and try it out

[Bob Pratl]

As JimD said "It's definitely a shooter (but not a looker IMHO)." is true. I will say that the Avenger was the first AG that I have ever purchased, out of the box, to shoot 1/2" groups at 50 yards consistently without any adjustments, mods or major teardowns. And it holds air for months.

[OldCrow]

I don't know why I would start a new topic on this rifle. 

This one thread has been a wonderful source of information so it might as well stay here.

I just got an Avenger Limited Edition. The Hunter version.  It looks a lot better in your hand than it does in the adverts.  There was one tiny ding in the stock.  Not going to worry about that.

I'm designing a moderator for it which inserts just like the endcap.  I think most of that work is done.  I have the endcap insert part running fine and it alone improves the noise level "noticeably" not "impressively".  A photo of that part is attached.

I've exported a drawing of the moderator part which I'm running on the printer now.  I expect it to fit the rifle and I expect it will perform well WRT moderation, accuracy will be a different question.

I will update here as experimentation progresses.

My story and I'm sticking to it.