Todays Shooting "Raptor Mini"

[rkr]

Good shooting Mike! Have you tried any other bullets from that barrel?

[KnifeMaker]

Ric, only the  29 gr noe's from a decked mold. Not quite as accurate. 100 fps faster. Still with in 1 inch at 50 yards. Just not pin point like the 39 gr's.


Stephen is gearing up to swage some test bullets for it, and as he stated, ordering a liner for is own use.


Mike

[AVS Stephen]

Stephen, I ordered 1 mm over which give only 1/2 mm in dia around the line. Hold one while I check what I ordered.


Mike


Stephen. I ordered 8 x 12 mm. id x od. Here is the link.


www.ebay.com/itm/Glossy-12mm-OD-8mm-ID-500mm-Length-3K-Roll-Carbon-Fiber-Tube-12-8-500/283042429200?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

Thank you Mike. Happy New year!

[Bob Pratl]

Stephen, I ordered 1 mm over which give only 1/2 mm in dia around the line. Hold one while I check what I ordered.
 I ordered 8 x 12 mm. id x od. Here is the link.

Michael, what Epoxy did you use to bond the CF tubing to the Brownells barrel?

[KnifeMaker]

Stephen, I ordered 1 mm over which give only 1/2 mm in dia around the line. Hold one while I check what I ordered.
 I ordered 8 x 12 mm. id x od. Here is the link.

Michael, what Epoxy did you use to bond the CF tubing to the Brownells barrel?

Sadly, I used JB weld. It started hardening 3/8" shy of being fully seated. GRRRR!!!


For the next project, I picked up some Loctite that takes 30 minutes of working time.


Man, after the fact! LOL  You know what they say about hindsight being 20-20. 


Mike

[Rob in NC]

Looks good, sir... color me jealous!

[KnifeMaker]

You too Stephen!


Happy New Year Every Body!!!

[anti-squirrel]

I keep coming back to this thread for the gold nuggets that keep dropping.