Dummy pins for side levers..

[cosmic]

Hi all, I ordered some stainless steel 5mm x 1" dummy pins  and don't need them all.. So I have 3 pairs to give away. Just pm me your name and address and i will drop them in a envelope and send them to you...
                                                      Ray

[Taso1000]

Hi Ray,

I was just going to post a new thread on what the dummy pin length should be for an RWS 48 and saw your post.  I have some brass rod but wasn't sure on the length to cut it to. 

Is one inch the correct length for the 48?  I know I read it somewhere before but can't find that thread now.

Thanks,

Taso

[cosmic]

Yes around 1"...

[cosmic]

You could go a little longer +1/16..
 One set gone, two still left...

[Roadworthy]

For those who want to know, the appropriate dummy pins for Dianas are 5 mm X 27 mm.  I think that works out to be about 3/16" X 1 1/16".

These are not specific to the 48.  They are good to use when dismantling any model.  They hold the internals in the trigger pack in place.

[cosmic]

One more set left.. Thanks Tom...

[cosmic]

OK all gone.....

[HectorMedina]

Thanks

That was really nice of you.

This is the kind of things that make me love airgunning.





HM

[cosmic]

Thanks Hector .. This is a great community !! To everyone that requested them, they are in the mail now...

[wabi]

Got mine in the mail today - THANK YOU!!!!!!!!!!!!!!! 

[redcobra04]

Got mine today. Thank. You.

[jumpin]

OK all gone.....

Ray, mine arrived today. Thanks a lot for your generosity. These pins are so much better than what I was using.
John

[cosmic]

No  thanks needed !! I have gained so much from this forum that any help I can give, I will... Now on to my stock mods...
                             Ray