Cleaning a Kral Puncher Breaker

[JimR]

Assuming mine doesn't break when I unbox it  is there anything I should know about cleaning it before I shoot it ? I assume I can run patches from the breech out the muzzle until they come out clean. IIRC when I got a Marauder it was recommended to remove the shroud so as not to damage the baffles but from what I understand the KPB doesn't have baffles........

[LeE]

Assuming mine doesn't break when I unbox it  is there anything I should know about cleaning it before I shoot it ? I assume I can run patches from the breech out the muzzle until they come out clean. IIRC when I got a Marauder it was recommended to remove the shroud so as not to damage the baffles but from what I understand the KPB doesn't have baffles........

I cleaned mine out with some balistol and JB bore paste before I ran any pellets through and polished the crown. It was full of junk. Just be careful of the crown and you will be ok.

[tinsoldier]

You definitely have to remove the shroud. Otherwise the patch will jam up inside the shroud. However becareful of the o ring holding the shroud to the barrel band. I tore mine up. I did notice a slight change in accuracy when I remove the o-ring so now I have to pay a visit to ACE hardware to find the proper size. 

[Erroln]

I never trust the brand new gun's barrel is ever clear of debris.  I usually remove baffles and take one 'dry' fire (if there is enough air in the cylinder or bottle) then start running patches through to make sure when I shoot the first pellet through, it doesn't catch on any debris left in the barrel and leave a permanent mark inside the barrel.