Group Buy - .25 cal Mold - Heavy Pellet for Hatsan & MRod Magazines

[rsterne]

The Group Buy for this pellet mold is now open.... Although this is a .25 cal, I put it in the Big Bore Gate to keep all the Group Buys together.... This pellet is designed to fit and function in both the Hatsan and MRod magazines.... Once Jeremy has received 5 paid orders, he will start work on the new pattern, and absorb the $35 pattern charge.... He has suggested a delivery time of about 10 weeks from that point.... Molds will be $135 for a single cavity, plus $25 extra for each additional base pin to allow a weight change.... Shipping is extra.... There are three suggested weights on the drawing.... All weights are calculated, but should be pretty close.... they may have changed slightly from the discussion thread.... You will need to specify the weight(s) that you want.... Here is the drawing....



To order, PM jkingsouthafrica to get the details on how to proceed.... If you are participating in more than one Group Buy, talking to him about it may save you some on the shipping.... Note that I am only the designer, I have no affiliation with Jeremy, all arrangements and obligations are between you and him.... Each Group Buy is a stand-alone, and not influenced by the status of the others.... If you decide to participate, please post here so that we know how many are involved in each Group Buy.... The molds fit the inexpensive Lee 6-cavity handles (not supplied)....


Bob

[Jmorris]

How do cast pellets perform vs swaged?

How is the base pin set up for bullet drop?

Is the spacing on a double cavity (if available) the same as say a Magma bullet mold so auto casters could be used?

[jkingsouthafrica]

9mm/357 cast JBS 81 grains 5 shot group 55 yards with a tuned Recluse 950 fps

[rsterne]

From Jeremy....

Double cavity mold will be $195  comes with 2  base inserts same type    optional base inserts to change pellet weight are $25 each

Bob

[OleTomCat]

Man, I posted in the wrong group buy the first time, I need to be in this group....

Bob, this one was not shown in the original thread as one of the final options, did we get enough interest to make this one?

Al

[rsterne]

Jeremy is keeping track of the numbers.... unfortunately, many guys are not posting in the thread their intent to purchase, so I don't have the up to date numbers.... Basically, if guys want a mold, the $35 pattern charge will be waived by Jeremy.... They will be built in the order that 5 guys pay....

Bob