Beeman R1 Stock Screw Torque in Inch Pounds?

[SSchmidt57]

I have an older R1 (Santa Rosa) that I dug back out of the gun safe to get reacquainted with.  I have searched the site for a starting point in Inch Pounds for the front and trigger guard stock screws.  Any guidance would be appreciated.

[brzryder]

Welcome aboard 

[SSchmidt57]

Thanks... I should have started out with something other than making a request  ... With the shortage of ammo it was great connecting with my old friend (Beeman R1)

[wilsonj1018]

shoot for around 15 in lbs if you need an approximate number. don't forget blue lock tite.
Josh

[amb5500c]

Welcome to the GTA.
Richard

[SSchmidt57]

Richard... thanks for the warm welcome...

Josh... Thanks for the direction.  I have the R1 tightended up and ready to go. 

Pellets are much better on the wallet than the 338 Lapua

[wilsonj1018]

ammo prices is what drove me to airguns as well.
Josh

[nced]

I have an older R1 (Santa Rosa) that I dug back out of the gun safe to get reacquainted with.  I have searched the site for a starting point in Inch Pounds for the front and trigger guard stock screws.  Any guidance would be appreciated.

A while back I did some searching for the recommended torque of 5mm screws like those used for the HW95/R9 forearm stock mounting screws. Well....I was surprised by the lightness of the recommended torque for a 5mm screw (only about 2 foot pounds). Since learning this a while back I haven't been "cinching the screws down TIGHT" , only "Just snugging them down" and they do stay with the "blue LocTite".

Here are a couple links to bolt torque specs and even a link to a "Nm to lb ft" converter.
http://www.yetmans.mb.ca/kohler/page3/page3.html
http://www.totallyamaha.com/snowmobiles/aaTECH/ausertech/Torque%20Specifications%20of%20Small%20Screws.htm
http://www.convertunits.com/from/N+m/to/lb+ft

[SSchmidt57]

Ed,
Thanks for the advice.  I does seem logical ( 2ft lbs = 24 In lbs)  this is in line with my thinking.  Based on all the input I will test for accuracy starting at 15 in lbs and moving up to say 25 In lbs. 

[wilsonj1018]

I was only throwing out a rough guess, as 15 in lbs is for the front forearms screws of a fwb 124, which in turn if loctited  just snug would likely do the job without interfering with accuracy.
Josh