difficulty removing Pneuma (AT44) barrel

[wasatch]

After loosening the two set screws under the rear sight I am unable to feel even the slightest bit of movement in the barrel when I try to twist it or pull it out.  I want to clean up the breech and transfer port.

Any suggestions?

[sr500]

Ihave the same problem on my BT65. Cant move it- On my AT44 it was easy. Whats wrong?

[ascarissuis]

Are you guys sure that the set screws ara all the way out?.

[wasatch]

I haven't taken my set screws all the way out but they were backed out such that only a thread or two were still in the breech block and there wasn't a bit of wiggle in the barrel.

Absolutely no movement pulling or twisting the barrel.

Considering its steel inserted into aluminum I'm wondering which would be better, heat it or freeze it to take advantage of dissimilar expansion (or contraction) rates.

Or maybe it has been loctited. In which case heat would be appropriate. But how much... hair dryer or propane torch?

[michael1969]

he has a screw under a rear sight.

[gerarddag]

some bt65 elite .25 have two set screws on the side also have a look there too.