First Mini-lathe Project: Stripper for QB79

[sr1sws]

Made my first real part on my mini-lathe today - a stripper for my QB79 "$200 PCP" made from delrin.  It attaches to the muzzle using the front site screw.  I drilled the exit hole 13/64" ~.20" for a tight tolerance for the .177 pellets.  Eventually this will go inside a half-shroud to tame the QB79's bark.  It seems to have improved accuracy some - no flyers in this target test (only 15 yards, size of my backyard range).

Steve

[Gertrude]

Very Nice work on the stripper, but please,... lets be very cautious about where this thread goes.

 Do not let it become a "how to build a...." thread.

 Please be very mindful of GTA forum rule #12.