Better day for my .22 NPSS

[Fisherdude]

Today I backed out the grub screw that keeps the pivot bolt from turning and sure enough it was a little loose.  I went ahead and pulled it apart and found that there is 0.010 in. clearance on each side of the barrel block.  One side of the barrel block was bored a little deeper than the other and the factory plastic washers just weren't able to fill the gap.  I went back with a 5/16 brass washer that was a few thousandths thicker and put her back together.  Once again I am able to make my swingers spin at 30 yard.  Yee Haw!!!

[Don C.]

Yep, bronze or brass washers do the trick! Keep an eye on them also, as mine wore in as the shots added up. A little tightening of the pivot screw from time to time keeps my gun happy!

[gene_sc]

Don C sent me some bronze washers a while back. Thanks Don. I am in the proceess of doing a tune one a new Titan GP. The washers Don sent me worked out great.

I had to do a bit of work on them so they would fit properly. In the end I had a great setup.