Carbine Stock to fit MRod Tube

[rsterne]

I just finished up my .25 cal MRod Carbine, here is a photo....



Now a close up of the stock, top view.... Note the adjustable butt-stock (shown in center position)....



and the bottom view....



It slides over a PRod trigger group, and the top is larger than my previous 2260/Disco versions, to fit the larger 1.25" OD MRod tube size.... I also raised the comb line level with the top of the main tube.... The forestock also slides over the tube, with a single 4-40 bolt to clamp is just in front of the trigger.... The larger clamp at the front uses four 8-32 screws to clamp to the 21mm OD carbon tubing I used as a shroud.... I uses Matter3D 10% CF-PETG and printed with a 0.6mm nozzle, using 0.3mm layers and a 0.9mm line width....

Bob