Another Impact question

[YEMX]

This question can apply to any euro gun, but what are the threads of the Impact pressure gauges?  Like, I know it's 1/8 "BSP".  But I'm trying to find a plug at McMaster, and they have two- BSPP and BSPT.  BSPP isn't tapered, and BSPT is tapered.  I would assume I'd get the BSPT, but now I'm questioning it.  I also don't want to buy multiple different types of plugs, because then I'll be stuck with useless bits in my house.  I don't need more of that!  LOL  I REALLY hate how confusing threads are.  TIA!

[Rick67]

Someone says it’s straight:


https://www.airgunnation.com/threads/fx-impact-mki-gauge-hole-plug.540929/


Not an FX, but I plugged my PROD gauge block with one from NAPA; brought my gauge block with me for a sure fit.

Very expensive though at $0.50 🥴

[Rick67]

The PROD GB threaded hole is not a BSPP though.

[YEMX]

NICE!!  Thanks for that link!

1/8 BSPP plug ordered!  I just wish McMaster had a allen key shouldered one, I think they look better than a hex head.  In the PSI range needed, that is.  Oh well.  Can't win them all! 

FX actually has a factory solution, but it's not used for the bottom port of the power block...  So I didn't want to order it for it to not work. 

[YEMX]

The BSPP plug from McMaster will work! I think!  LOL  BUT after chatting with Utah Air again (They're probably getting tired of talking to me!  LOL), I found out that FX HAS come up with a solution for those that remove the gauge in the power block: "PN 10294 Plug, Gauge".  So if you're looking for a "factory" solution, there you go.  This is different from M4 "PN: 20734, Plug for Manometer".  Which plugs the left gauge on the receiver- where the M3's first stage reg gauge was.