Benjamin 392 and Benjamin 342.

[furstheimer]

2018 Benjamin 392 with hard plastic butt plate to increase LOP to 14 inches, Mac 1 billet plug/ pump lever and adjustable piston kit and Mac 1 pull knob on bolt, part of an old scope mount of the type now sold by Baker Airguns as the one piece scope mount and an older no-name 4X scope that allows proper hand position for pumping. I wish I knew enough about the scope so I could get another. I will replace scope rings with lower ones once I find some. Wood forearm modified by me No other internal modifications. Very accurate.

1981 Benjamin 342 placed in a modified Beeman R10 stock and matching, as close as I could, pump lever wood. No internal modifications but rear sight installed backward so I had a place to put my hand during pumping. Shoots well but retains air after 6 pumps.

I have other pumpers but these get shot most often.

[35 shooter]

Nice setup on the scope on the 392 for hand placement to pump with.
I went with a Mac1 base and a 2x7 utg pistol scope to accomplish the same thing.