Problem with vevor compressor

[Madd Hatter]

Thing is is, it didn't give me problems until after I had the complete top end off and reinstalled.

Something may have been dislodged during the repair and plugged it up.. I'm just taking stabs at the cause here.

That's what I'm thinking. The hole in it isn't very large and could be plugged easily.

[Madd Hatter]

Got a new one for ya'lls. lol The low pressure vent screw keeps backing out while I'm filling my rifle. It's gotten to the point I'm holding the screw to keep it in place until I'm done filling. Anybody had that problem? The rifle is filling just fine when the pressure filling the rifle drops almost 1K psi. When it first happened I'm thinking now what's gone wrong???

[USAFANG6799]

I put a spring behind it to keep some tension on both the low and high screw.
Hasn't moved since.

[Madd Hatter]

Good advice there Matt.

[Killfire]

I've crushed a couple white washers before. I just take a small drill bit and drill the hole back out while it's installed.